organ bike, folding deck, fork

The hoses give it kind of an H.R. Giger aesthetic. I dig it.

This organ trailer is finally coming together. Going to powdercoat tomorrow.

Rolling 3/4" tube for the canopy hoops.

Thrust reversers.

Canopy frame done.

Trying to propagate from cuttings.

These beautiful bellows were made by Terry Lambert. The raised "dais" part houses a check valve for one-way air flow.

The bellows are driven off linkages from this set of shortened bicycle cranks.

This deck project is also wrapping up. It's a deck for the back of a school bus. It folds down on heavy-duty hinges.

There are four of these 5/8"-pin bullet hinges.

This plate is for mounting a spiral staircase that goes up to another deck on top of the bus.

Disc brake mount on fork.

Still some flux residue from brazing on the crown race, but this shows the wire-tunnel inside the fork leg for generator light wiring. It's a 6mm stainless tube that comes out just above the dropout.