I didn't really take too many photos of the new CBC trailer before sending it off to be powdercoated. Here's a look at the underside of the frame:
And here's one of the hitches. It's basically a beefed-up Burley hitch, made to accept a 1/2" rod end.
The side panels awaiting installation:
Below is a VFD for my belt grinder. VFD stands for Variable Frequency Drive. It allows me to run a three-phase motor on a single-phase outlet, and also allows for speed control and braking of the motor. Since it's going to be mounted on a grinder, I have to make a filtered, forced-air enclosure to keep out the grinding dust while ventilating the hot air.
The octagonal hole in the box is for the exhaust fan. The square bezel on top will hold the filter. I'm really getting a lot of use out of weld-nuts these days.
Test-mounting the VFD and the exhaust fan in the enclosure.